The silicone button can be waterproof, but the waterproof wall should be added when designing, and the outer casing should be added with a waterproof structure so that it can be used in practical use. In order to be waterproof enough, it is necessary to consider the design structure. Step by step.

Silicone button waterproof design:
1. The water tank seal manufacturer introduces that the button must be designed with no positioning holes. If the positioning hole is designed, there is water on the button, and water may flow from the positioning hole into the circuit board, causing the circuit board to be short-circuited or damaged.

2. Secondly, the button also needs to have a waterproof edge on the side of the design. The waterproof edge refers to a waterproof wall around the outer edge of the silicone button, a waterproof wall with a slightly higher height than the bottom of the button, combined with the actual situation of the case, in the waterproof The wall edge is designed with a fixed position to design a waterproof silicone button.

The manufacturer of the water tank gasket should also pay attention to the fact that the strong light will cause the shorter the light wave, the greater the energy, especially the ultraviolet light. Its effect on silica gel is similar to that of heat. The slight difference is that light mainly acts on the surface of silica gel, which causes performance degradation and product damage in silicone rubber products. In the process of use, you need to clean it. You can use dry cleaning as much as possible. Wipe it with a dust-free cloth. You can also put it in warm water and wipe it dry. Then put it in a ventilated place. It is also possible to use stains to clean the stain. It is also necessary to know the silicone products. Not easy to clean, so do not easily clean and wipe and expose.