In the production of silicone products, will receive the influence of some factors, eventually lead to some of the products is not ideal, such as bad appearance, which contains even more, to know some method of repair, believe that we can solve the problem quickly, which is like by the user.

Silica gel products repair:
1, tank gasket company introduction silicone products numbness in bad repair methods. Numbness of bad causes a lot of silicone products, rely on good control mould mild exhaust in repair.

2, silica gel products stain bad repair methods. For the stain on the surface of the silica gel products break method is to look at the surface stains, if on the surface of the stain is very shallow small them gently with fine sand paper burnish, if the stain is deep or is larger, the stain of first place in the blade cut, the blade is sharp, dig the incision neatly.

3, silica gel products package wind bad repair methods. Choose a few not cooked or not off white silica gel products. Are not familiar with the local mode caused by low temperature can be not familiar rubber press tight, again into the mold vulcanizing, the inappropriate as to exhaust the white point pressing by hand, and can usually press drop, but not directly in the mould for vulcanizing, pressurized repair bad refer to lack of glue dry.

4, tank gasket company introduction silicone products dark mark bad repair methods. Silica gel products of the dark mark bad there is no method of repair, so can avoid the dark mark.