At the time of making, always will appear all sorts of conditions, bad things always will be, will make the surface looks not good, this needs us to understand some of the ways to repair, so as to better use, to ensure that the whole beautiful, also can reduce labor costs.

Silica gel products repair:
1, numb toxic silicone products. Appliances rubber hose manufacturer to introduce silicone products cause numbness adverse for many reasons, by control good mould mild exhaust in repair. Silica gel products bad dark mark. Silica gel products of the dark mark bad there is no method of repair, so can avoid the dark mark.

2, silica gel products stain. For the stain on the surface of the silica gel products break method is to look at the surface stains, if on the surface of the stain is very shallow small them gently with fine sand paper burnish, if the stain is deep or is larger, the stain of first place in the blade cut, the blade is sharp, dig the incision neatly.

3, silica gel products package wind is bad. Choose a few not cooked or not off white silica gel products. Are not familiar with the local mode caused by low temperature can be not familiar rubber press tight, again into the mold vulcanizing, the inappropriate as to exhaust the white point pressing by hand, and can usually press drop, but not directly in the mould for vulcanizing, pressurized repair bad refer to lack of glue dry.

4 rubber pipe manufacturer to introduce silicone products, home appliances of rubber bad repair methods. Can only choose a slight lack of material, where the lack of glue to fill some raw rubber, must not much, just rough or can be a bit less, use the blade to make up the raw rubber, vulcanizing and add the forming dies. Note that the time must be pressurized repair mode of the machine, rail of the machine will products when clamping pressure bias.