A lot of silica gel products have all kinds of bad happens, the same processing is completed, the weight will appear error, this is mainly a gap in design drawings and the actual product, such as commonly used silica gel plate cases, the cause of adverse situation more.

Silicone tablet cases bad situation:
1, tank gasket manufacturer to introduce external wind, external packages, wind products external appear white bubbles. A drum can be divided into several kinds of phenomena, the cause of temperature is not enough, after the mold die out residence time is too long, spraying mold release water too much, time is too short, the mold vulcanization exhaust is different from travel.

2, silica gel protective sleeve inside and outside are not ripe, pits. Curing time is too short in the process of production with the machine may result in the low temperature of phenomenon vulcanization not completely, not familiar with raw material placed too long lead to failure, rubber vulcanization agent pits phenomenon is the main reason is because the mold temperature is too high, put the speed of the raw material can't keep up with

3, mold. Mold processing as the core role, also be more strict to the requirement of appearance, a piece of good steel stamping can increase the use of mould number tens of thousands of times, so for the appearance of discharge and so on are available from mold, looking for reasons, such as the depth of the groove, the nesting mould clamping line size and so on.

4, the reason of tank gasket manufacturer to introduce personnel. Personnel arrangement is also important, green is slower than the speed of a master and understand the possible product doesn't have much experience in the manufacturing process of defective rate will be higher, so it is very important to strengthen the consciousness of prevention and control of fuck machinist.